Posts made in December, 2019

Lower Your Energy Bills With Attic Insulation

Do you feel a cold draft coming from the attic? This can freeze your house in the winter. There can be unsealed crevices or cracks in your attic that requires insulation and sealing. Also, musty, damp, and cold attics attract mildew and mold that’s hazardous to your health.

Of course, you can always turn up the heat to stay warm. However, this will only increase your utility bill.

It is time to think about insulating it if your attic isn’t finished. This can keep your home cool in the summer and warm in the winter, stabilize room temperature, and save you as much as 15% up to 45% on your utility bills.

Since it can attract rodents and rats to burrow in as it wears out, old attic insulation should also be replaced and cleaned out with fresh new spray foam insulation Arkansas.

Types of Attic Insulation

The air in your house leaves over the attic. Therefore, to keep y our home warm adequately, your cooling/heating system has to work harder. Your utility bills increase whenever additional heating is needed. To control the temperature and lower energy bills, you can install a smart thermostat. However, you can add comfort while lowering the strain on your HVAC system and saving money if you insulate your attic with additional layers of insect and fire-resistant material.

Loose Fill

Adding additional material to the floor is the simplest way to insulate the attic. You can do this by getting rid of the planks to add blanket insulation or loose-fill insulation over the floor. The loose-fill fibers are packed in bags and installed using unique equipment to the density and depth needed. A contractor can blow the fill in place. Loose-fill can be made of recycled consumer paper, cellulose, melted sand, recycled glass, fiberglass, and much more. There are fibers made of recycled blast furnaces or rock as well. However, they are much more expensive compared to loose-fill materials.

Several Types of Insulation

Spray Foam – This type of insulation expands to seal any gaps tightly from where air can escape. Thus, it’s also known as the most energy-efficient type. In addition to that, it works better compared to other types and outperforms all types of insulation.

Blown-In – This type of insulation is resistant to moisture. It also keeps odor and molds away. To prevent air from leaking out, it enables loose-fill to flow into smaller crevices.

Roll-On – This is probably the cheapest and simplest type of insulation. It snugly fits between rafters and studs. This will also keep that air inside effectively.

How Does This Work?

Insulation is normally measured by its thermal resistance, also known as the R-Value. Your house will have better insulation if the insulation has a high R-Value. To keep your home warm in the winter season, your attic requires a minimum of R-49 insulation on average. On the other hand, for warmer regions, R-38 is required. You should talk to your insulation contractor to know what’s best for your home.

Read More

How Can Clogged Gutters Destroy Your Home?

If the gutters get blocked, the water can pool around your house’s foundation. Gutters are those channels connected to the edges of the roof. They are designed to collect the water that lands on the roof when it’s raining or after the snow has melted. Gutters ensure that water goes to the ground safely. 

Gutters are slightly angled to lead water towards the downspout. The downspout allows water to properly reach the ground. The ends of downspouts are curved to make sure that the water is directed away from the foundation of your house. Without any gutter installed, or if it is clogged or faulty, then the water will fall next to your house and create a pool right there. 

Why You Don’t Want Water in the Basement  

When water pools on the ground or surface, many problems will occur. First, the water will cause the soil below it to get fully saturated, and that will put huge stress on that side of the house. In time, the lower walls, particularly in the basement, will push inwards and break. 

As the water drains, the ground starts eroding and then will settle down. This can eventually lead to uneven floors and cracks in walls and fireplaces. When cracks become visible in your home’s foundation, water will seep through it. Even if the crack will not cause your home to collapse, you’ll still have problems with mold growth. 

How to Keep the Gutters Clean  

Because of all these possible damages done to your home due to standing water, you surely want your gutters working in the best possible way. Throughout the year, particularly during fall and spring, trees produce debris, like leaves and twigs, that clog the gutters. 

Preventing such blockages can be done simply. Just clean up the downspout and gutters twice a year and you’re all set. If you consider yourself a handyman, then that means climbing up the ladder on your own and taking out all the gunk in there.  

How to Hire Gutter Cleaning Experts 

If you don’t want to climb a ladder, you can hire a gutter cleaning contractor to help you out. They will charge you a minimal fee for their services, which is better than doing the job on your own and risking getting an injury. You may also install gutter covers or protections, such as inserts and screens. Although there’s always that possibility that you’ll have to get your gutters repaired after some time, the chance of it getting clogged and cause all these problems are minimized. 

Hire professional gutter cleaning contractors to get the best possible results. Take extra care in choosing who you hire. Ensure that the company maintains a great track record and is covered by insurance. Ask your neighbors for recommendations. Most Waterloo gutter installers also provide cleaning services. High are the chances that the ones who installed your gutters can come back to your home to get it cleaned on a regular basis. Inquire about that service, including how much it will cost you. 

Read More

Recent Comments